Some amplifier applications require clamping or limiting due to large, sporadic signals appearing at the amplifier input. Clamping these errant signals protects the amplifier and other sensitive downstream circuitry. It also improves overdrive recovery time and can lower distortion.

At the heart of the clamp circuit described here is the AD8099 high-speed, low-noise, externally compensated amplifier. The device consists of a single-stage amplifier followed by a unity-gain buffer. External compensation is required in low-gain applications, but not with gains of greater than 10. The clamper exploits that feature by setting the amplifier for a gain of 15, eliminating the need for a compensation network. The compensation pin can then be used in an unconventional manner to provide clamping.

The clamping circuit employs two 1N5711 high-speed Schottky barrier diodes connected to the compensation pin through resistor R3, which limits the current in and out of the compensation pin (Fig. 1). In this application, the current is approximately 6 mA. It should be kept below 10 mA for safe operation.

The diodes perform the lion's share of the clamping function. They feature very low capacitance and picosecond switching, thus maintaining high-frequency performance and crisp transition edges.

The drop across R3 is about 0.6 V, which combines with another 0.4 V across D1 or D2 to make the total drop approximately 1 V. With ±2-V references, the amplifier output clamps at ±3 V.

Without the clamping network in place, overdriving the amplifier's input with a 1-V, 5-MHz square wave causes the amplifier to rail. Asymmetry, distortion, and other signs of overdriving are clearly visible at the amplifier's output (Fig. 2). With the clamping circuit incorporated, the output is clamped to 3 ±V, and the asymmetry and distortion effects of overdriving have been eliminated (Fig. 3).

Reprints

Printer-Friendly

Email this Article

RSS

Submit PlanetEE del.icio.us Digg Reddit Newsvine StumbleUpon Netscape Yahoo MyWeb Live Bookmarks Fark  Submit

Font Size

What's This?

Ground-Fault Relay Avoids Nuisance Trips Low-Cost Common-Mode Chokes Deliver High Performance Front-End Supplies Take Digital Control Up A Notch Power-Entry Modules Now Offer Vertical Flange Mounting Bluetooth Modules Scrub For Medical Apps Laser Diode Performs At 1,400 nm To 2,000 nm

Engineers Rely On Internet For Product Info Rochester Electronics Establishes New Design and Technology Group Custom Sources Light Way To 22-nm IC Lithography In EDA, A Year Of Mergers, Failed And Otherwise Software Turns Scopes Into Vector RF Signal Analyzers Couple’s $15 Million Gift Advances Rice Engineering Education November 7, 2008 Startup Sets Sail For Speedier Spice Simulation

1) Ten Top Design Skills For Tough Times (3289 views today) 2) Build A Smart Battery Charger Using A Single-Transistor Circuit (331 views today) 3) Energy Harvester Perpetually Powers WIreless Sensors (322 views today) 4) Ultracapacitors Branch Out Into Wider Markets (300 views today) 5) Technology Has Been Very Good To Obama, And He Plans To Reciprocate (184 views today) ALL TOP 20

Reader Comments network modul How many Anonymous -September 10, 2008 i don,t know Circuit ( Pls u have circuit explain i will understand,) Anonymous -September 10, 2008 can u tell me Basic Circuit Function Anonymous -September 10, 2008 Hi, i need help from ur side, what is clamping function in Network Anonymous -September 10, 2008 clamping circuits dolly -March 21, 2008 Please send me the Rf design circuits surya -June 20, 2007
POST YOUR COMMENTS HERE Name: Email:
Your Comments: Enter the text from the image below Please refresh the page if you have trouble reading this text.